This unit allows you to control an analogue point motor from your digital controller.
The PM60 is the same single output accessory decoder as used on our Digital motors so is proven to work with both lightweight and heavy duty solenoid motors. Featuring a 2 wire connection and a built in CDU to ensure reliable operation, it’s also a learning unit so no complicated programming is required - just a controller with accessory control. The PM60 also features a pre resisted LED output for panel or signal lighting as well as terminals for analogue switch operation. This analogue switch feature is very popular as it uses high-tech development to give you a traditional result. The PM60 has simple terminal block connection and a detachable pre built harness for motor connection and the unit can be used to upgrade both the PM20 and PM10 or the standard 3 wired connection as used with Seep, Hornby, Peco etc. A pre fitted sticky pad allows simple no fuss fixing as well as two 3.5mm fixing holes for additional security (screws not supplied).